[smg id=575]
The BAL leveler was too small for my 15 inch tires. I used a scissors jack to carefully open the ends of the BAL leveler to the point were it would fit around my tires.
[hr]

[smg id=576]
It is very important that the BAL leveler screw is greased and kept clean. I use a piece of insulating foam to keep the screw covered when not in use.
[hr]

[smg id=577]
This is a close up of the covered screw. I use a large thumb screw to thighten or loosed the clamp. When tightened, I can carry the BAL level by holding the foam.
[hr]

[smg id=578]
The BAL leveler is placed under the tire which needs to be raised. The end of the screw needs to placed in a ring at the base of the leveler. The wrench is turned clockwise to raise the tire and anticlockwise to lower it.
[hr]

[smg id=579]
The leveler in a raised position. I use a 18 Volt DeWalt drill to raise and lower the BAL leveler. The attachments include:
1. 1/4" hex to 1/2" square adapter
2. 1/2" extension rod
3. 3/4" socket
[hr]

Courtesy of He Ruide [Image Can Not Be Found]